Place the microscope body on the table.

Take the fluorescence module.

The power switch is on the right.

Secure the fluorescence template using the slot and tighten with a wrench.

Then take the eyepiece and secure it using the slot and the screw at the front.

Then take and secure the camera connector.

Take the camera, remove the packaging, and screw the camera directly onto the connector.

Adjust as needed.

Take the two eyepieces and place them directly on the eyepiece frame.

Take the power supply and connector from the fluorescence module.

Take the data cable that came with the camera. Plug one end into the camera and the other end into the computer.